| Производитель | FÄSSLER |
| Модель | D 250 H5 |
| Год выпуска | 1983 |
| Мах. Модуль | 5 |
| Расстояние между центрами | 0 |
| Диаметр заготовки | 250 |
workpiece diameter: 250 mm
centre distance: 0 mm
honing length max: mm
max module: 5
Gear Ø, min./max. 10 / 250 mm
Module range 1 - 5
Length of teeth / max. table stroke 500 mm
Height of centres of tailstocks 220 mm
Max. weight of workpiece 50 / 100 kg
Honing head swivelling +/- 35 °
Speeds of honing tool 20 - 500 rpm
Size of honing tool, Ø x width 300 x 40 mm
Workpiece speeds 500 - 3,000 rpm
Total adjustment of cross slide 270 mm
Rapid traverse of cross slide 50 mm
Infeed travel of cross slide, mechanical 1 - 8 mm/Ø
Roughing / finishing infeed 1 - 29 / 0.2 - 2.8 mm/sec
Table speeds, hydraulic 0 - 6 m/min
Total electrical load 5.5 kW - 380 V - 50 Hz
Weight 3,200 kg
Accessories / Special Features
Working parameters can be preset using counters and control units. Automatic working process with workpiece counter.
All roughing and finishing infeeds can be adjusted by a decade switch; as well as by table reverse times and fast infeeds with preset times (1sec = Ø 0.04 mm), set on a potentiometer. Ampere display, etc.
Convex honing and conical honing are possible via templates. Asymmetric honing is also possible if the workpiece is prepared appropriately (i.e. pre-shaped).
Separate honing oil unit with magnetic separator and fine filter.
Mechanical tailstocks for manual loading. Oil mist separator.
Sliding doors with foot switch. Separate hydraulic unit.
Condition : Good. Machine can be inspected under power.
Delivery : Ex stock, as inspected.
Payment : Net, after conclusion of contract.
We have a large selection of gear machines available. Please let us know your requirements.
